Girders and long loads are normally transported on dollys and jinkers. We operate a fleet of dollys and jinkers to allow clients to schedule many deliveries at once

Shown below is a typical setup for 65 tonne T-roth girders



 Not only long and heavy loads require Jinkers, this footbridge was taken to position at the Royal NSW Golf Course.


Many of these enormously strong girders were built for Adelaide's newest Shiplifter, the girders were loaded using the 120T Lifting system.


 Rex J Andrews P/L has been transporting long loads for a long time, this gantry belongs to the formwork for Anzac bridge in Sydney.


PO Box 271, Penrith NSW Australia 2751
32-36 Lugard St Penrith NSW 2750
Ph: 02 4721 7633

PO Box 6072, Burton SA 5110
103-105 Helps Rd Burton SA 5110
Ph: 08 8280 5541

Po Box 271 Penrith NSW 2751
16 Yilen Place, Beresfield NSW 2322
Ph: 02 4721 7633

PO Box 271, Penrith NSW Australia 2751
219 Portland-Nelson Rd, Portland VIC
Ph: 02 4721 7633

Rex J Andrews reserves the right to alter this information at any time

Rex J Andrews Pty Ltd makes no warranties, expressed or implied, in relation to the information contained in, including but not limited to warranties relating to the accuracy, completeness or applicability of the information, and excludes all liability for any damage, whether direct, indirect, special or consequential, arising in any way out of the use or misuse of the information.

© 2021 Rex J Andrews Pty Ltd.           Back to Top